meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
hw:via805 [2019/12/20 21:04] – niziak | hw:via805 [2019/12/20 21:14] – niziak | ||
---|---|---|---|
Line 57: | Line 57: | ||
<code bash> | <code bash> | ||
+ | |||
+ | {{: | ||
+ | |||
+ | < | ||
+ | Targeted VID = 1106 | ||
+ | Targeted PID = 3483 | ||
+ | |||
+ | ISP file size: 24246(DW) | ||
+ | |||
+ | FW file = 013704.bin | ||
+ | VL805/VL806 is found. | ||
+ | Bus=1, Dev=5, Func=0 | ||
+ | , Chip Verision=B1 | ||
+ | |||
+ | Cannot Recognize SPI Flash, Try Default Flash Command To Download... | ||
+ | spi erase | ||
+ | |||
+ | pageSizeDW = 64 | ||
+ | |||
+ | wait while programming... | ||
+ | |||
+ | Update ISP Success. | ||
+ | </ | ||
+ | |||
+ | |||
+ | [[https:// | ||
+ | After some research I was able to successfully upgrade after editing the SpiFlash.ini file with the parameters of the 25P10VP chip on my board. | ||
+ | |||
+ | I added the following: | ||
+ | |||
+ | <file | SpiFlash.ini> | ||
+ | |||
+ | |||
+ | 21=25P10VP | ||
+ | |||
+ | |||
+ | |||
+ | [25P10VP] | ||
+ | FlashID = 202011 | ||
+ | ReadID = 9F | ||
+ | WriteEnable = 06 | ||
+ | WriteStatus = 01 | ||
+ | ChipErase = C7 | ||
+ | ReadData = 03 | ||
+ | ReadStatus = 05 | ||
+ | PageProgram = 02 | ||
+ | ClockRate = 32 | ||
+ | PageSize = 10 | ||
+ | |||
+ | </ | ||
+ | |||
+ | < | ||
+ | Targeted VID = 1106 | ||
+ | Targeted PID = 3483 | ||
+ | |||
+ | ISP file size: 24246(DW) | ||
+ | |||
+ | FW file = 013704.bin | ||
+ | VL805/VL806 is found. | ||
+ | Bus=1, Dev=5, Func=0 | ||
+ | , Chip Verision=B1 | ||
+ | |||
+ | Match gFlashType No. = 21, FlashType = 25P10VP | ||
+ | |||
+ | spi erase | ||
+ | |||
+ | pageSizeDW = 64 | ||
+ | |||
+ | wait while programming... | ||
+ | |||
+ | Update ISP Success. | ||
+ | |||
+ | </ | ||
To detach the same device, use: | To detach the same device, use: |