meta data for this page
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| hw:server:raid [2021/04/08 14:28] – niziak | hw:server:raid [2021/04/08 19:48] – niziak | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== RAID ====== | ||
| + | * RAID0 - striping | ||
| + | * RAID1 - mirror | ||
| + | * RAID5 | ||
| + | * do not use | ||
| + | * very slow write | ||
| + | * rebuild takes days, and during rebuild another disk may fail = fatal | ||
| + | * RAID6 - striping with double parity (5+2, 13+2). | ||
| + | * minimum 4 disks | ||
| + | * allow 2 disk failure | ||
| + | * slower write than RAID5 (requires udpate parity on 2 disks) | ||
| + | |||
| + | Recommended levels for safety: | ||
| + | * RAID10 = RAID 1 + 0 = i.e two mirrors (RAID1) stripped as RAID0 | ||
| + | * RAID6 | ||
| + | * RAID60 = RAID 6 + 0 - two RAID6 sets stripped as RAID0 | ||
| + | |||
| ====== Raid controllers ====== | ====== Raid controllers ====== | ||
| + | * controllers where RAID can be disabled, and all disks are exposed to host are called: '' | ||
| + | * H200 | ||
| + | * H310 ??? | ||
| + | * PERC 6 (no '' | ||
| ===== Dell ===== | ===== Dell ===== | ||
| - | * SAS6 | ||
| * SAS1 - 3Gbps | * SAS1 - 3Gbps | ||
| + | * SAS5E | ||
| + | * SFF-8470 connector | ||
| + | * supported by MD3000 (the same SFF-8470 connector) | ||
| + | * SAS6E | ||
| + | * SFF-8088 connector | ||
| + | |||
| * PERC 6 | * PERC 6 | ||
| * no memory | * no memory | ||