meta data for this page
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
hw:server:matrix [2021/03/04 10:22] niziak |
hw:server:matrix [2021/04/08 19:35] (current) niziak |
||
|---|---|---|---|
| Line 19: | Line 19: | ||
| * H800 controler with large disks support | * H800 controler with large disks support | ||
| * | * | ||
| - | ===== Dell PowerVault MD1000 AMP01 ===== | + | ===== Dell PowerVault MD3000/MD1000 ===== |
| + | **!!! MD3000 has integrated RAID controller. ** | ||
| + | * Do not use it with PERC 6e or similar. | ||
| + | * Use simple SAS5E or SAS6E HBA adapter | ||
| + | |||
| + | |||
| + | MD3000 vs MD1000: | ||
| + | * the same enclosure. | ||
| + | * MD3000 is a base module, contains EMM with raid support (AMP01-RSIM). | ||
| + | * MD3000i is a base enclosure like above but EMM supports two ethernet ports for iSCSI and one SAS expansion port. | ||
| + | * seen as virtual device for dumb HBA | ||
| + | * redundant connections (dual path) | ||
| + | * 512 MB cache mirrored in each EMM | ||
| + | * RAID is performed inside enclosure, so multiple device access is not consuming bandwidth on 3Gbps SAS port. | ||
| + | * MD1000 is expansion module, contains simple dumb pass through EMMs (AMP01-SIM) | ||
| + | |||
| + | |||
| + | [[https://www1.la.dell.com/lc/en/corp/Storage/pvaul_md1000/pd.aspx?refid=pvaul_md1000&s=corp|MD1000]] | ||
| + | [[https://www.dell.com/support/home/en-la/product-support/product/powervault-md3000/docs|MD3000]] | ||
| + | |||
| + | * Enables mixing SAS and SATA drives in a single enclosure | ||
| * 15 drives backplane. | * 15 drives backplane. | ||
| - | * Old 3Gpbs SAS enclosure | + | * Enclosure modes: |
| - | * To be use with perc5e and perc6e. 32 bit addressing limits disks to 2TB. | + | * unified mode for direct connectivity to 15 hard drives |
| - | * Specification capacity 15x2TB max. | + | * split mode with dual EMMs providing a direct connectivity to drives 0 though 6 and a separate direct connectivity to drives 7 though 14. |
| + | * Possible bandwidth increase with soft raid using 2 x 3Gbps cabling | ||
| + | * Daisy chaining is not supported in split mode | ||
| + | * Old 3Gbps SAS enclosure | ||
| + | * To be use with PERC5e and PERC6e. 32 bit addressing limits disks to 2TB. | ||
| + | * Specification capacity 15 x 2TB max. | ||
| * People reports that MD1000 backplane supports 3TB drives max. | * People reports that MD1000 backplane supports 3TB drives max. | ||
| Line 32: | Line 57: | ||
| * There is label on disk caddy "SAS" or "SATAu" | * There is label on disk caddy "SAS" or "SATAu" | ||
| * SATAu caddy has interposer mounted, and disck is mounted a bit shifted to front to make space for interposer card | * SATAu caddy has interposer mounted, and disck is mounted a bit shifted to front to make space for interposer card | ||
| + | |||
| + | Hints: | ||
| + | [[http://www.jebriggs.com/blog/2009/12/md1000-and-md3000-redundancy-matrix/]] | ||
| + | |||
| + | |||
| + | ==== Enclosure Management Module (EMM) ==== | ||
| + | |||
| + | At least one EMM must be installed (in primary left EMM bay). | ||
| + | |||
| + | |||
| + | === AMP01-RSIM === | ||
| + | * (R) - RAID controller ? with 512MB ram ? | ||
| + | * one or two (multihost) IN ports (multiple standards, depends on product number) | ||
| + | * one SAS OUT port to next enclosure | ||
| + | * one mangement ethernet port | ||
| + | * default IPs: 192.168.128.101 and 192.168.128.102 | ||
| + | * one service port (6 pin mini-DIN - for factory use only) | ||
| + | |||
| + | Part number: | ||
| + | * M999D,59V6C,6706C,GY794 - Single host one SAS IN | ||
| + | {{:hw:server:pasted:20210408-121052.png}} | ||
| + | |||
| + | * 0P2GW4, MW736, CM669, MW726, X2R63, P809D, - 2x iSCSI IN ethernet ports | ||
| + | {{:hw:server:pasted:20210408-120139.png}} | ||
| + | |||
| + | |||
| + | * 0P2GW4, 0CM670 2x SAS IN (dual host) ports | ||
| + | {{:hw:server:pasted:20210408-120211.png}} | ||
| + | |||
| + | === AMP01-SIM === | ||
| + | * One SAS port ''IN'' | ||
| + | * One SAS port ''OUT'' to chain to next matrix | ||
| + | Part numbers: | ||
| + | CK614 | ||
| + | TH262 | ||
| + | HM240 | ||
| + | JT517 - SAS/SATA | ||
| + | {{:hw:server:pasted:20210408-115417.png}} | ||
| + | |||
| + | |||