Table of Contents

Placement Groups

PG

Calculations

reweight

Adjust reweight according to current OSD utilisation - to prevent filling one OSD

ceph osd reweight-by-utilization

In CRUSH hierarchies with a smaller number of OSDs, it’s possible for some OSDs to get more PGs than other OSDs, resulting in a higher load. You can reweight OSDs by PG distribution to address this situation by executing the following:

ceph osd reweight-by-pg 101

NOTE: 101 is a oload parameter, which means overload percentage for consideration 101%. For example, an argument of 200 would reweight OSDs which are twice as utilized as the average OSD.

Balancer

When the cluster is healthy, the balancer will incrementally move a small fraction of unbalanced PGs in order to improve distribution. This fraction will not exceed a certain threshold that defaults to 5%. Set it to 1%:

ceph config set mgr target_max_misplaced_ratio .01